19. Power on the printer using the power switch on the power brick. The
printer will begin purging shipping fluid into the temporary spittoon. This
process will take approximately twenty minutes.
20. The printer will cap the printhead When the process is finished. Discard
the temporary spittoon being careful not to spill any shipping fluid that
was not absorbed by the spittoon.
21. Power off the printer using the silver power button on the electronics
tray.
22. Unplug the AC Power and Ethernet from the power brick.
23. Disengage the kickstand, rotate it back to its home position and lower the
electronics tray.
24. Place the enclosure over the frame by aligning the back of the cover and
rotating it to the front.
25. Use the six Philips flat head screws to secure the enclosure to the frame
using a Phillips screwdriver.
To Next Page
Loading...
Need help?
General