18 www.neutonpower.com
Step 8: Insert the Battery after Being Fully Charged
1. Orient the Battery as shown in Figure 21a. Align the black side of the Battery with the side of the
Mower housing where the label reads “Insert Battery with the black side along this edge.”
NOTE: The indentations on the bottom of the Battery must line up with the metal tabs in the bottom the
Battery compartment. A new replacement Battery now has a gold faceplate (originally black as
seen in Figures 21a and 21b below).
2. After confirming the correct orientation of the Battery, insert the Battery fully into the Battery
compartment.
3. Turn the Battery Retainer Arm back over on top of the Battery to secure it in place (Figure 21b).
IF THE BATTERY IS NOT ORIENTED CORRECTLY, IT WILL NOT FULLY DEPRESS INTO THE OPENING. IF THIS
HAPPENS, REMOVE THE BATTERY, RECHECK THE ORIENTATION, AND TRY AGAIN.
Retainer Arm
Figure 21b
Figure 21a
Label
To Next Page
Loading...
Need help?
General
