Neuton CE5.2 User Manual

NEUTON CE5.2 Battery-Powered Mower - Safety & Operating Instructions 17
Installing the Bagger
1. Raise the Discharge Guard on your Mower
(Figure 17) and note the metal Support
Rod at the rear of the Mower.
2. Grasp the Bagger by the Top Handle
(Figure 18) and center it at the back of the
Mower.
3. Align the Metal Latch Hooks (Figure 18)
over the Support Rod (Figure 19) and
lower the Bagger in place until the Wire
Frame at the bottom of the Bagger rests
on the Mower.
4. Lower and close the Discharge Guard.
Removing and Emptying the Bagger
1. Raise the Discharge Guard.
2. Using the Top Handle of the Bagger, lift
the Bagger off the Support Rod and away
from the Mower.
3. Lower the Dischage Guard.
4. To empty the Bagger, tilt the Top Handle
forward. Use the Cloth Handle (Figure 20)
at the rear of the Bagger to move the
contents toward the front as you empty
the Bagger.
Figure 1
7
Discharge
Guard
Support Rod
Figure 18
Figure 19
Figure 20
Cloth Handle
Top
Handle
Latch Hooks
Support Rod
Latch Hook

Neuton CE5.2 Specifications

General

Brand	Neuton
Model	CE5.2
Category	Lawn Mower
Language	English