Neuton CE6.3 User Manual

NEUTON CE6.3 Battery-Powered Mower - Safety & Operating Instructions 9
Removing and Emptying the Bagger
1. Raise the Discharge Guard and using the Top Handle of the Bagger, lift the
Bagger off the Support Rod and away from the Mower. Lower the
Discharge Guard.
2. To empty the Bagger, tilt the Top Handle forward. Use the Cloth Handle
(Figure 18) at the rear of the Bagger to move the contents toward the front
as you empty the Bagger.
Step 6: Insert the Battery after being fully charged.
1. Orient the Battery as shown in Figure 19. Align the black side of the Battery with the side of the Mower housing where the
label reads “Insert Battery with the black side along this edge.”
NOTE: The indentations on the bottom of the Battery must line up with the metal tabs in the bottom of the Battery compartment. A
new replacement battery now has a gold faceplate (originally black as seen in Figures 19 and 20 below).
2. After confirming the correct orientation of the Battery, insert the Battery fully into the Battery compartment.
3. Turn the Battery Retainer Arm back over on top of the Battery to secure it in place (Figure 20).
If the Battery is not oriented correctly, it will not fully depress into the opening. If this happens, remove the Battery, recheck the
orientation, and try again.
Figure 18
Cloth
Handle
Retainer Arm
Figure 20
Figure 19
Label

Neuton CE6.3 Specifications

General

Brand	Neuton
Model	CE6.3
Category	Lawn Mower
Language	English