Neuton CE6.3 User Manual

8 www.neutonpower.com
Mulching Plug
To mulch your grass, install the Mulching Plug.
1. If necessary, remove the Rear Bagger or Side Discharge Chute from the
Mower.
2. Install the Mulching Plug (Figure 11). Be sure to push the Plug all the way in.
There’s a slight knack to installing the Plug; push the Plug in
with a slightly arcing motion as follows:
• Align the Plug in the Mower.
• Start to push the top of the Plug in first.
• Then put pressure towards the bottom and slide in the Plug.
Rear Bagger
The NEUTON Rear Bagger lets you cut and catch your grass clippings, eliminating the need to rake. The Rear Bagger
easily attaches to the rear of the Mower (Figure 12). The Bagger shipped unassembled. The following instructions
outline the steps necessary to assemble, install, and remove the Bagger.
Assembling the Bag to the Bag Frame
1. With the Bottom Stiffener Board facing down, insert the Frame into the Bag (Figure 13).
2. Snap the Bag Clips around the Frame top, sides and bottom (Figure 14) to secure the Bag to the Frame.
Installing the Bagger
1. Raise the Discharge Guard on your Mower (Figure 15) and note the metal Support Rod at the rear of the Mower.
2. Grasp the Bagger by the Top Handle (Figure 16) and center it at the back of the Mower.
3. Align the Metal Latch Hooks (Figure 16) over the Support Rod (Figure 17) and lower the Bagger in place until the Wire
Frame at the bottom of the Bagger rests on the Mower. Lower the Discharge Guard.
Figure 16
Figure 1
7
TIP
Figure 11
Latch Hook
Support Rod
Rear Bagge
r
Figure 12
Frame
Figure 13
Stiffener Board
Bag Clips
Figure 14
Figure 15
Discharge
Guard
Support
Rod
Latch Hooks
Top Handle

Neuton CE6.3 Specifications

General

Brand	Neuton
Model	CE6.3
Category	Lawn Mower
Language	English