GB
│
IE
│
NI
│
13 ■SMD 24 A1
Cleaning and care
DANGER – ELECTRIC SHOCK!
► Always pull out the plug before cleaning the appliance. There is a risk of electric
shock!
► The appliance must be completely dry before connecting it to the socket again.
Never submerge the main unit
w or the hand unit 4 in water or other liquids!
CAUTION – PROPERTY DAMAGE!
► Do not use any aggressive cleaning agents or solvents. These could damage the
plastic surfaces of the appliance.
♦ Remove the nozzle attachment
2 from the hand unit 4 and rinse it off under running
water.
♦ Clean the main unit w and the hand unit 4 with a soft, slightly damp cloth. For
stubborn soiling add a little mild detergent to the cloth. Afterwards, wipe off with a
cloth moistened only with pure water. Then dry off the main unit w and the hand
unit 4 with a dry cloth.
♦ Remove the water tank e from the main unit w and open the lid t of the water
tank e. Rinse the water tank e under running water. After cleaning, pour the
remaining water out of the water tank e into the washbasin.
♦ If you do not intend to use the appliance for a longer period, remove the lid
t from
the water tank e. Allow the water tank e to dry completely in air before placing it
back in the main unit w.
Storage
♦ Disconnect the appliance from the power supply by pulling the plug of the switched-off
appliance from the socket.
♦ Remove any water from the appliance and allow the appliance to dry completely
(see section Cleaning and care).
♦ Store the appliance in a dry and dust-free location out of direct sunlight.