17
Appendix (
Chronometer
)
EXAMPLE
To Set The Chronometer:
A. Set the Chronometer to 12:00:00
Do The Following Steps:
1. Press SET --- then CHRONOMETER.
2. The control will ask ---
DO YOU HAVE AN AUXILIARY TIME DISPLAY
CONNECTED?
--- (Answer this question appropriately.)
NOTE: This question is asked only once for each time the control is started fresh by entering a model code.
It may be ask from SET OPTIONS or from SET CHRONOMETER. The control needs this information in
order to know what other questions to ask and how certain data should be handled. Auxiliary Time Display
models include: 9410, 9510, 9405 and 9505.
3. The control will ask ---
DO YOU WANT TO DISPLAY CHRONOMETER TIME ON
AUXILIARY TIME DISPLAY?
--- (Press No).
NOTE: This question will only be asked if you answered yes to “DO YOU HAVE AN AUXILIARY TIME
DISPLAY CONNECTED?”
4. The control will ask ---
ENABLE CHRONOMETER KEY TO PUT
CHRONOMETER TIME ON SCOREBOARD?
--- (Press No).
5. The control will ask ---
SET CHRONOMETER?
--- (Press Yes).
[__SET_HH:MM:SS___]
--- (Enter the hours, minutes, and seconds).
NOTE: The time is based on a 12 hour clock.
[__Y/N_12:00:00___]
--- (Press Yes).
NOTE: It usually takes the control about 2 seconds to process and
actually set the internal clock after Yes is pressed.
To Previous Page
Loading...
