New Holland TD 60D - HYDRAULIC LIFT AND STEERING SPECIFICATIONS

SECTION 8 -- SPECIFICATIONS
8--8
REAR TRANSMISSION
B
e
v
e
l
g
e
a
r
r
a
t
i
o
30 km/h -- 2WD 30 km/h -- 4WD 40 km/h -- 4WD
B
eve
l
--gear rat
i
o
9/43 9/43 11/43
Differential with pedal controlled locking device and automatic release.
Final drive : Pinion -- gear type
POWER TAKE--OFF (PTO)
Fully independent, in three versions : 540 rpm; 540, 750 and 1000 rev/min; (540 and 1000 rev/min not for all
markets). With engine running at :
PTO (rev/min)
Engine (rev/min)
540 2200
750 (540 Economy) 2380 (1715)
1000 2380
Ground speed PTO (see page 3--8).
Manual control : clutch control lever, take--off engage lever and speed selector lever .
Direction of rotation, viewed from rear of tractor : clockwise.
HYDRAULIC LIFT
Operates in the following modes :
-- draft control;
-- position control;
-- mixed control;
-- float mode.
Draft control is through the link arms by means of a torsion bar.
The link--arms are raised and lowered using a pushbutton--operated device Lift--O--Matic
TM
.
Oil supply is from the transmission by gear pump operated directly by the engine :
type C31.......................................................................................
-- pump speed with engine at maximum power (rev/min): 2328.......................................
-- corresponding nominal flow: dm
3
/min / l/min (US. gal/min): 40.1 (10.8).............................
-- corresponding nominal flow (Mega Flow Pump*): dm
3
/min / l/min (US. gal/min): 51.7 (13.6)...........
-- pressure relief valve calibration : bar (Psi) 190 (2755).............................................
(kg/cm
2
)194...............................................
* Optional