SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--31
TRANSMISSION WITH RANGE GEAR -- 30 km/h (19 mph)
(12 FORWARD GEARS + 4 REVERSE GEARS -- SYNCROMESH)
(NOT AVAILABLE IN ALL MARKETS)
CAUTION
With the engine running and with just one gear lever
in neutral, the tractor could be started accidentally if
the lever is knocked, with consequent accident risk.
To prevent this happening, move both levers fig. 63
to neutral, lower any attached equipment and stop
the engine before leaving the tractor.
The transmission and range gears are controlled by
two separate levers.
The main shift lever (1) fig. 63 selects four gear ratios
(1, 2, 3, 4).
The range lever (1) fig. 64 provides three forward
gear ranges and one reverse range R for each gear
ratio.
There are twelve forward and four reverse gears.
To change from a medium gear to a lower or higher
one, stop the tractor, move the range lever to the right
and shift it forward for lower gears or backward for
higher gears.
To engage reverse R, stop the tractor and move the
range lever to the left and then shift back.
To change from one speed to another in the same
range, shift the main shift lever after releasing the
clutch. (The tractor does not have to be halted as the
gears are Synchro--engaged).
1
63
Range lever positions -- Fig. 64
-- I = l o w
-- II = medium
-- III = high
-- R = reverse
1
64
To Next Page
Loading...
