Setting up your Squat Magic
Everything you need to get started on your Squat Magic is in your pack.
Follow these simple steps to build it:
Step 1
Remove all packaging and stand the product upright,
checking it is locked into the base. The tube should
be twisted clockwise until the 3 small holes align
with the arrow on the base. This should be checked
before every use.
Step 2
Select the assistance level you require and stretch
the bands, twist locking them in place so the
arrows on the plug point upwards. Place caps in the
remaining holes.
Place plug in hole with cut-out
segment facing down.
Twist plug clockwise
until segment faces left*.
*Plug is in locked position when small triangle points upwards.
7
To Next Page
Loading...
