www.newair.com 13
OPERATING INSTRUCTIONS
When you plug in the power cord, the power indicator will turn on. Before
operating the ice maker, follow these cleaning instructions:
CLEAN
It is highly recommended to run the self-cleaning function before first use.
1. Check the drainpipe behind the appliance and make sure the water drain
cap has been inserted into the drainpipe; otherwise, the appliance will not
work properly.
2. Press the “CLEAN” button. The power light will turn on for 5 seconds and
then begin to flash. The cleaning procedure will last for 15 minutes. Once
the cleaning cycle has ended, the power light will turn off. Press the
“CLEAN” button again to turn of the function.
3. Once the cleaning process has ended, drain the excess water by
positioning the ice maker near a drainage source. Remove the drain plug
from the back, pull out the plug from the drainpipe and let the water drain
out completely. Then reinsert the plug.
To Next Page
Loading...
Need help?
General
