12
motor from running, position the handle matching the arrow marker on
level 0.
8.3.2 Adjusting Motor Depth
Position the depth adjustment collar so the propeller blades are sub-
merged 6inches - 12inches (15cm - 30cm) below the surface of the
water.
8.3.3 Adjusting Steering Tension
Tighten or loosen the steering tension adjusting knob to increase or
decrease the steering tension. You can also lock the motor direction by
tightening the steering tension adjusting knob rmly.
8.3.4 Raising The Motor
It is recommended to disconnect the battery before carrying out this
procedure to prevent accidental running of the motor. To raise the motor
out of the water push and hold the tilt lever and with the other hand
push down on the end of the handle to bring the motor up and out of
the water. Then release the tilt lever to lock in place.
8.3.5 Lowering The Motor
It is recommended to disconnect the battery before carrying out this
procedure to prevent accidental running of the motor. Press the tilt
lever, while with the other hand; hold onto the end of the handle to
steady the motor into the water. Once lowered release the tilt lever to
lock into position.
Remember to wash the motor with fresh water
after being used in salt water, as it can greatly reduce the possibility of
corrosion.
To Next Page
Loading...
Need help?
General
