Accessories
SAFETY recommendation for all accessories
• Always inspect all components for damage before assembly. If you suspect that any of the
components are defective DO NOT USE THE AFFECTED PARTS.
• Carefully read the assembly instructions shipped with each accessory.
• Secondary safety steels must be installed once the system has been flown to operating height.
Secondary steels must be fitted irrespective of the local safety standards applicable to the territory.
• When deploying the flying accessories, always wear protective headwear, footwear and eye
protection.
• Do not allow inexperienced persons to handle flying systems. Installation personnel should be
trained in loudspeaker flying techniques.
• Ensure that motor hoists, hoist control systems and ancillary rigging components are currently
certified as safe and that they pass a visual inspection prior to use.
• Ensure that public and personnel are not allowed to pass beneath the system during the installation
process. The work area should be isolated from public access.
• Never leave the system unattended during the installation process.
• Avoid flying cabinets over areas where the audience has access.
Stand, Mast & U Coupler
PS8, PS10 and PS15 have a built in 35 mm (1 3/8”) diameter stand adapter. Cabinets can be positioned
directly on a general-purpose speaker stand or on a mast inserted in the stand adapter fitted on top of the
LS400, LS500 & LS1200. The U-Coupler accessory allows positioning and relative rotation of two
cabinets arrayed side by side on top of the mast or on a speaker stand. The mast and U-coupler for the
PS8 and PS10 are available as options. For safety reasons the use of this U-coupler with the PS15
cabinet is not recommended.
PS10 & PS15 Flying rails & Rings
PS10s and PS15s are equipped with steel anchor plates (standard)
that can be fitted with the following fittings (optional):
• Top: 6 position aircraft-flying rail. (9 for PS15)
• Bottom: two single position round aircraft flying rails.
(two 3-position aircraft flying rails for PS15)
These rails are supplied as part of optional flying kits containing all
necessary screws and 4 single stud aircraft flying rings. Heavy-duty
double stud flying rings can be used in all rails except the bottom
PS10 points. Installation requires a metric N°5 Allen key or TORX
30 (to remove the original back plate screws) and a metric N°4
Allen key/ TORX 30 to fit the rails.
To Next Page
Loading...
Need help?
General
