- Installation instructions for supplementary outriggers -
Via Mediterraneo, 6 - 42022 - Boretto - Reggio Emilia - Italy
Tel. +39 - 0522-96 30 08 - Fax +39 - 0522-96 30 39
info@maxiliftcrane.com
- 30 -
17 - FINISHING AND PAINTING OF “MAXISTAB” STABILIZERS
The stabilizers are supplied painted with EPOXY priming coat of half-luster black colour.
This product is an excellent support, after the mounting and installing operations, for the application of a
final paint, as mentioned in the warning decal applied to each stabilizer.
In order to prevent future rust dripping from the slits of the demountable parts connections (for instance:
cylinder sleeve/stabilizer cylinder coupling), we suggest to seal such parts by seams of silicone-base
products before going on with the final paint.
In order to achieve the best aesthetic and protective result, after degreasing the stabilizer, we suggest to
rub slightly the black coat by fine-grained abrasive paper, and to apply one or two coats of final paint in
the desired colour and of following type:
- POLYURETHANE
- ACRYLIC
- POLYACRYLIC
To Next Page