- Installation instructions for supplementary outriggers -
Via Mediterraneo, 6 - 42022 - Boretto - Reggio Emilia - Italy
Tel. +39 - 0522-96 30 08 - Fax +39 - 0522-96 30 39
info@maxiliftcrane.com
- 2 -
MACHINE DIRECTIVE
All the equipments sold within the European Union’s territory must fulfil the regulations of the 2006/42/EC Directive
(MACHINE DIRECTIVE) in the version in force.
Therefore, each Maxistab stabilizer is fitted with the safety devices required, it bears a plate carrying the CE mark
in a visible position, and is delivered accompanied by relevant Conformity Declaration.
The installer carrying out mounting, by incorporating the Maxistab stabilizer in the vehicle, produces a new machine:
crane (or others) on a vehicle, ready to be put into service. Therefore, he becomes the manufacturer of this new
machine, and must comply with the Directive’s provisions concerning design, building, safety in functioning and use.
He must keep all of this recorded in the Technical Dossier he is compelled to draw up.
After making sure, by proper tests and practical exams, of the correspondence to the requirements, the installer
places his own CE plate, and releases his own Conformity Certificate.
NOTE
We remind that the non-fulfilment to the above involves, in case of accidents:
- criminal sanctions
- fines (compensation for economic damage caused by defective product)
- withdrawal from the market of the machine itself, and in case also of others of the same series.
REFERENCE NORMS
Directives 2006/42/EC.
Norm EN 12999 in the version in force.
Norm CUNA NC 034-05 (Release 1984), Norm DIN 15019.
INSTALLATION AND MOUNTING INSTRUCTIONS, from Manufacturers of various industrial vehicles.
Use manuals of hydraulic hoses, from various Manufacturers.
Use manuals of hydraulic steel pipes and fittings, from various Manufacturers.
Use manuals of pumps and PTO’s, from various Manufacturers.
To Next Page