Please note: Remove the protective film after assembly of this product unless it is stated in
the steps to do so - this will prevent accidental scratches during assembly
STEP ONE
PARTS
FITTINGS
1. Please remove the protective film from the surface of
panel 2
2. Insert 10 x cambolts (C) into panel 2 and tighten with a
screwdriver.
1. Glue and insert 5 x wooden dowels (A) into
panel 2.
2. Attach panels 5 (x2) to panel 2.
3. Insert 10 x camlocks (D) into panels 3 (x5).
Ensure the arrow indicators are pointing towards
the panel edges before tightening with a
screwdriver.
STEP TWO
Page 2 of 4