Next PARIS BED - Step Four: Attach Support Rail and Leg; Step Five: Insert Slats; Step Six: Adjust and Position Bed

1. Attach central support rail 6 to headboard 1 and
footboard 2 with 8 x bolts (A), 8 x flat washers (D) and
8 x spring washers (F).
2. Attach central support leg 7 to central support rail 6
using 2 x bolts (C), 2 x nuts (G) and 4 x flat washers
(E). Tighten with a crosshead screwdriver and
spanner (K).
1. Insert slats 8 into end caps (I) and double end caps
(H) as shown.
2. Insert each end cap into corresponding holes in 2 x
side rails 3 and central support rail 6. Repeat process
for each slat.
NOTES:
* The curve of the slat must be facing upwards.
* Number of slats and caps vary dependant on size.
Quantities as shown in FITTINGS and PARTS
sections.
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
STEP FIVE
STEP FOUR
STEP SIX
C
E
E
G
Page 4 of 4