29
Photo Viewer
The unit is designed with an SD card slot and supports JPEG
format files playback. To use the Photo Viewer, you will need to
have an SD card with your JPEG picture files preloaded. Please
note that you cannot use the navigation function of the device at
the same time you are using the Photo Viewer. Remove the SD
Mapping Data Card that comes with the device from the SD card
slot on the side of the unit. Then insert your SD card with your
JPEG picture files.
Note: Please take special care of the Mapping Data Card if
you remove it to use the Photo Viewer as the navigation
function will not work without it.
If the unit lags when reading JPEG files, try using lower
resolution files. We suggest 640 x 480 pixel resolution files.
Tap
in the system main menu to enter the Photo Viewer,
as shown below:
To Next Page
Loading...
Need help?
General
