1
Accessories
USB Cable DC Adaptor Pouch
Buttons & Ports
Step by Step to Get Started
STEP 1 Charge the Battery
Plug the DC adaptor to the POWER-IN port of the
unit and the standard 220V power socket to start
charging. It takes about 5 hours to fully charge the
battery. The charge indicator should light up in
orange once the battery is fully charged.
STEP 2 Transfer files
(1) Connect the device to computer with the supplied USB cable.
(2) Two new removable disk drives should appear on your computer standing for the internal
memory of the device and the memory card inside it.
(3) Copy files to the removable disk drive just as you would do to your hard drive.
(4) On your computer, left click the icon at the right bottom corner of the desktop and then
click the pop-up message “Stop the USB Mass Storage Device – Drive (X).” to disconnect
the device from the computer safely.
7” Capacitive Touch Android Tablet
Quick Start Guide
NX007HD8G
Ver.1.1
A. Power button – press and hold to
power on or off the unit; briefly
press to turn on or off the screen.
B. VOL+ - turn up the volume
C. VOL- - turn down the volume
D. Earphone Port – connect to stereo
earphones.
E. POWER-IN port - connect to
F. Micro USB Port – connect to computer, USB
disk, keyboard or mouse through USB cable.
G. Micro SD card slot
H. HDMI interface
I. Front Camera lens
J. Charge indicator
K. Touch screen
L. Rear camera lens
M. Built-in speakers
To Next Page
Need help?
General