Nextech 8011410 - Troubleshooting Common Issues

10
If a fault occurs, rst check the points listed below before taking the unit for repair.
Do not open the unit as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the unit yourself, as this will void the warranty.
PROBLEM SOLUTION
NO SOUND OR POWER Volume not adjusted Adjust the volume
Power cord not securely
connected
Connect the AC power cord correctly
Batteries dead or incorrectly
inserted
Insert (fresh) batteries correctly
DISPLAY DOES NOT
FUNCTION PROPERLY/
NO REACTION TO
OPERATION OF ANY OF
THE CONTROLS
Electrostatic discharge Switch off and unplug the unit.
Reconnect after a few seconds
POOR CASSETTE
SOUND QUALITY
Dust and dirt on the heads,
etc.
Clean deck parts etc.,
(see Maintenance)
Use of incompatible cassette
types (METAL or CHROME)
Only use NORMAL (IEC I)
for recording
RECORDING DOES
NOT WORK
Cassette tab(s) may be broken Apply a piece of adhesive tape over
the missing tab space
NO DISC INDICATION No CD inserted Insert a CD, CD-R or CD-RW
CD badly scratched or dirty Replace/clean CD,
(see Maintenance)
Laser lens steamed up Wait until lens has adjusted to room
temperature
CD-R is blank or the disc is not
nalized
Use a nalized CD-R
CD PLAYBACK DOES
NOT WORK
CD badly scratched/dirty Replace/clean CD (see Maintenance)
Laser lens steamed up Wait until lens has adjusted to room
temperature
THE CD SKIPS TRACKS CD damaged or dirty Replace or clean CD
Program mode is active Quit program mode(s)
Environmental Information
We have done our best to reduce the packaging and make it easy to separate into 3 materials;
cardboard, polyethylene and expandable polystyrene. Your equipment consists of materials that can
be recycled if disassembled by a specialized company. Please observe the local regulations regarding
the disposal of packaging, dead batteries and old equipment.
Troubleshooting