Need help?Do you have a question about the NI 6320 and is the answer not in the manual?
General| Analog Inputs | 16 |
|---|---|
| Resolution | 16 bits |
| Sampling Rate | 250 kS/s |
| Connectivity | USB |
| Analog Outputs | 2 |
| Digital I/O | 8 |
| Counter/Timers | 4 |
| Input Voltage Range | ±10 V |
| Operating Temperature | 0 °C to 50 °C |
Provides essential safety information for operating NI 63xx X Series devices and modules.
Covers the necessary steps for installing application software and NI-DAQmx driver.
Explains how to perform self-calibration on the X Series device after installation.
Offers best practices and features specific to X Series USB devices.
Describes the DAQ hardware, including common components and the DAQ-STC3 digital engine.
Describes the signals found on the I/O connectors, including analog and digital signals.
Describes analog input circuitry and configuration for MIO X Series devices.
Details differential, referenced single-ended, and non-referenced single-ended input modes.
Covers software-timed and hardware-timed acquisition methods.
Explains start, reference, and pause trigger actions for analog input.
Provides recommended input configurations for various signal sources.
Explains start and pause trigger actions for analog output operations.
Details start, reference, and pause trigger actions for digital input.
Details start and pause trigger actions for digital output operations.
Lists various counter input applications like edge counting and frequency measurement.
Details counter output applications such as pulse and frequency generation.
Explains arm start, start, and pause trigger actions for counters.
Explains how to generate a trigger on a digital signal, specifying source and edge.
Describes generating a trigger on an analog signal for X Series devices.
Addresses common analog input issues like crosstalk and ghost voltages.
To Next Page