Need help?Do you have a question about the NI 6366 and is the answer not in the manual?
General| Analog Input Channels | 16 |
|---|---|
| Maximum Sample Rate | 2 MS/s (aggregate) |
| Resolution | 16 bits |
| Digital I/O Channels | 24 |
| Counter/Timer Channels | 4 |
| Communication Interface | USB |
| Analog Output Channels | 2 |
| Analog Output Resolution | 16 bits |
| Bus | USB |
| Input Voltage Range | ±10 V |
| Digital I/O Compatibility | TTL |
| Digital I/O sampling rate | 10 MHz |
Provides essential safety instructions for operating NI 63xx X Series devices and modules.
Details the steps for installing application software, NI-DAQmx, and hardware for DAQ devices.
Explains how to perform self-calibration on X Series devices for accurate measurements.
Covers best practices and features for setting up and using X Series USB DAQ devices.
Provides detailed descriptions of signals found on the I/O connectors of X Series devices.
Details the analog input circuitry and configuration for MIO X Series devices.
Covers differential, referenced single-ended, and non-referenced single-ended input modes.
Details the start, reference, and pause trigger actions for analog input.
Explains how to set the analog output range and its impact on resolution.
Details the start and pause trigger actions for analog output operations.
Details the start, reference, and pause trigger actions for digital input.
Details the start and pause trigger actions for digital output operations.
Explains how to generate triggers using digital signals like PFI, RTSI, or PXI_STAR.
Details generating triggers on analog signals, including device-specific options.
Addresses common analog input issues like crosstalk and signal drift.
Resources for obtaining technical support, including online help and forums.
To Next Page