Page 8 For technical questions, please call 1-888-866-5797. Item 56645
Inspection, Maintenance, and Cleaning
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM PRODUCT FAILURE:
Do not use damaged equipment. If abnormal noise, vibration, or
leaking air occurs, have the problem corrected before further use.
Follow all guidelines regarding chemicals sprayed, including MSDS instructions and EPA regulations.
1. BEFORE EACH USE, inspect the general
condition of the Sprayer. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER EVERY USE, clean the Sprayer:
a. Flush with water.
b. Clean Nozzle, Handle Filter, and Tank Filter.
c. Rinse with water and allow to air-dry
with the Tank open.
3. PERIODICALLY, lubricate all moving parts of
the pump assembly with petroleum jelly.
4. STORAGE
Store Sprayer in a safe, dry, clean location out
of reach of children and out of sunlight.
Cleaning the Handle Filter
1. Remove Trigger Assembly from the Wand
by turning it counter clockwise.
2. Remove the Wand Handle from the
Trigger Body by turning it counter clockwise.
3. Carefully remove the Handle Filter,
saving all pieces.
4. Flush Filter with clean water.
5. Reassemble Trigger Assembly.
Wand Handle
Handle Filter
Trigger Body
Trigger Sealing
Ring
Trigger Assembly
To Next Page
Loading...