3.
Pull the insulation straight out.
Assembly
ERS S10 is installed using the enclosed rail on a solid
wall. Noise from the fans can be transferred to the rail.
• Install with its back to an outside wall, ideally in a room
where noise does not matter, in order to eliminate
noise problems. If this is not possible, avoid placing
it against a wall behind a bedroom or other room
where noise may be a problem.
• Wherever the unit is located, walls to sound sensitive
rooms should be fitted with sound insulation.
• Condensation water comes from the HRV unit. A
condensation outlet with a water seal must be in-
stalled and routed to an internal drain.
• The HRV unit’s installation area always has to have a
temperature of at least 10 °C and max. 35 °C.
INSTALLATION AREA
Leave a free space of 800 mm in front of the product.
NOTE
Ensure that there is sufficient space (300 mm)
above the HRV unit for installing ventilation
hoses.
Mounting
When hanging on a wooden wall, a vibration damper is
recommended to prevent vibration being transferred.
1.
Install the enclosed bracket to the wall.
2.
Install ERS S10 on the brackets.
3.
Screw ERS S10 firmly into place on the bracket.
NIBE ERS S10-400Chapter 2 | Delivery and handling32
F
To Next Page
Loading...