Nibe ERS S10-400 - Commissioning and Adjusting; Preparations; Filling; Start-Up and Inspection

Preparations
• Check the miniature circuit-breaker (FC1) in the main
product. It may have tripped during transportation.
• Check that the air filters are clean, they can become
dirty after installation.
Filling
• Check that there is water in the water seal, fill if ne-
cessary.
Start-up and
inspection
SETTING THE VENTILATION
The ventilation must be set according to applicable
standards. Adjust the supply air flow to guarantee a
negative pressure.
The settings are made in menus 5.1.5 and 5.1.6.
Even if ventilation is roughly set at installation it is im-
portant that a ventilation adjustment is ordered and
permitted.
Caution
An incorrectly set ventilation flow can damage
the house and may also increase energy con-
sumption.
NOTE
Order a ventilation adjustment to complete the
setting.
Ventilation capacity
0
0 10 20 30 40 50 60 70 80 90 100 110 120
100
200
300
400
500
600
Tillgängligt tryck
(Pa)
Flöde
(l/s)
30%
100%
80%
60%
40%
50%
70%
90%
Available pressure
Airflow
Fan rating
1
0
100 20 30 40 50 60 70 80 90 100 110 120 130
10
20
30
40
50
60
70
80
90
Effekt
(W)
Flöde
(l/s)
30%
100%
80%
60%
50%
90%
70%
40%
Output
Airflow
1
The diagram shows the power consumption per fan.
NIBE ERS S10-400Chapter 6 | Commissioning and adjusting40
F
Commissioning and adjusting