TIP
If you wish to set similar scheduling for every day of the week start
by filling in “all” and then changing the desired days.
TIP
Set the stop time earlier than the start time so that the period extends
beyond midnight. Scheduling then stops at the set stop time the day
after.
Scheduling always starts on the date that the start time is set for.
HEATING
SCHEDULING HEATING 1.3.1
activated
schedule 2
system
schedule 3schedule 1
all
mon
tues
wed
thur
fri
sat
sun
21:30 - 06:00
20.5°
Time period AdjustingDay
Activated Schedule System
Conflict
Increases or decreases in the accommod-
ation temperature can be scheduled here
for up to three time periods per day. If a
room sensor is installed and activated the
desired room temperature (°C) is set
during the time period. Without an activ-
ated room sensor the desired change is
set (of setting in menu 1.1). One step is
usually enough to change the room tem-
perature by one degree, but in some
cases several steps may be required.
Adjustment: How much the heating curve
is to be offset in relation to menu 1.1
during scheduling is set here. If a room sensor is installed, the desired room
temperature is set in °C.
Menu
1.3.1
Caution
Changes of temperature in accommodation take time. For example,
short time periods in combination with underfloor heating will not give
a noticeable difference in room temperature.
COOLING (ACCESSORY REQUIRED)
Menu
1.3.2
31Chapter 3 | F1255 – at your serviceNIBE F1255
To Next Page
Loading...
