Page | 2
Positioning of F2040 (outdoor unit)
➢ Position the F2040 as close as practically possible to the VVM320, a Maximum of ten metres between units is recom-
mended to minimize heat loss and reduce running costs.
➢ Install on a solid Base or wall bracket (second story height not recommended).
➢ Leave space around unit for to ensure good air circulation. (Distances specified are minimum not a target)
➢ Avoid installation adjacent to sensitive areas e.g. bedrooms; noise levels are lower than most oil or gas boilers.
➢ 300mm clearance below unit is specified by NIBE due to frequent snowfalls in Sweden. UNIPIPE Ireland leave the
minimum clearance to the discretion of the plumber, however, if left below 300mm and snow damage is encountered,
UNIPIPE will not accept responsibility for any damage incurred.
To Next Page
Loading...
