Need help?Do you have a question about the Nibe F2050-10 and is the answer not in the manual?
General| Type | Air Source Heat Pump |
|---|---|
| Heating Capacity | 10 kW |
| Cooling Capacity | 8.5 kW |
| COP (Coefficient of Performance) | 4.5 |
| Power Consumption (Heating) | 2.2 kW |
| Refrigerant | R410A |
| Operating Temperature Range (Heating) | -20 to +35 °C |
| Power Supply | 230V, 50Hz |
This manual describes installation and service procedures for implementation by specialists.
The heat pump must be permanently connected to a 230 V 50 Hz supply.
Guidance on placing the heat pump outdoors on a suitable base and considering placement.
Lists and describes electrical components like boards, fuses, and fans.
Lists compatible products and provides connection details for heating medium circuit.
General guidelines for electrical installation and wiring according to national provisions.
Selecting communication address for F2050 in cascade connections using DIP switches.
Checks required before commissioning: charge circuit, climate system, pipe system for leaks.
Procedure for filling and venting the heating medium system.
Settings for the installed heat pump on the indoor module/control module.
Graphs and tables showing resistance/voltage for various temperature sensors.
Recommendations for annual checks and servicing by a qualified engineer.
Checklist for inspecting the condition of the casing, grille, fan, connections, and system.
Steps for inspecting and adjusting heating system temperatures, curves, flow, and charge flow.
Basic actions and tips for resolving operational interference and malfunctions.
Troubleshooting steps for when the F2050 heat pump fails to start.
Checks for correct addressing and communication cable connection.
Troubleshooting steps for low hot water temperature or no hot water.
Dimensional drawings for F2050-6 and F2050-10 models.
Graphs showing heating capacity and COP at different temperatures.
Table detailing heating and cooling capacity, power input, and COP.
Table showing seasonal heat output and SCOP values for different climates.
Table listing electrical specifications like voltage, current, fuse, and enclosure class.
Details on seasonal energy efficiency class, rated heat output, and energy consumption.
Tables detailing declared capacity and COP at various temperatures.
Checklist for system controls like time/temperature, zone valves, safety interlock, sensors.
Checks for system filling, pressure, surface stability, flushing, cleaner, inhibitor, frost protection.
Checks for compliance with building regulations, electrical regulations, and manual demonstration.
To Next Page
