Nibe PELLUX 100/20 - Heating System Management; Heating Control Modes (Automatic vs. Manual); Parameter Adjustment and Room Temperature Settings

PELLUX 100/20, PELLUX 100/30
11
To Users
Heang
Heang
General

  
 
 
 
  
 
 
 
 



Basic Modes of Operaon of the Boiler




Outside Temperature Sensor











Room Temperature Sensor (Opon)




Manual control of the boiler working temperature (sys-
tem without mixing valve)



Seng the Automac Control of the Heang
System
Adjustment of the Factory Set Parameters






Boiler Regulator Sengs
Basic Parameters for Auto Control of the
Heang System




Manual Temperature Change in the Rooms

Comfortable tempProgramme
Economical temp


Wait a day between successive sengs to allow the
temperature to stabilize.
ATTENTION
Temperature increase in the room can be limited by
a thermostat installed on the radiator or in underoor
heang. In such a situaon, you should increase its
setpoint.
ATTENTION