Nibe PELLUX 100/20 - Electrical Connections and Module Integration; Boiler and Control Panel Wiring

To Installers
PELLUX 100/20, PELLUX 100/30
17
Electrical Connecons
Electrical Connecons
Connecon
Internal Overvoltage Protecon



Control Panel Connecon
L
H
GND
+12V
GND
CAN
+12V






  
  





see Boiler Regulator Sengs





  
  
  
  
  
  
  
  
  
  
  



Only an appropriately authorized and qualied elec-
trician may connect the electrical installaon and per-
form its servicing. The electrical installaon and cable
roung must be done in accordance with applicable
regulaons.
ATTENTION
No other electrical equipment may be connected to
the boiler power supply line.
ATTENTION
Power supply of the heang system must be discon-
nected when connecng the control panel.
ATTENTION
Connecon may only be performed with power sup-
ply disconnected and only by an individual appropria-
tely authorized to do it.
ATTENTION
Always remember to install the terminaon at the
end of each CAN communicaon path. This is required
even when connecng a single communicaon
module.
ATTENTION