Nibe PELLUX 100/20 - Draught Regulator and Initial Boiler Settings

To Installers
PELLUX 100/20, PELLUX 100/30
21
Boiler Installaon
Draught Regulator
Draught regulator installaon
Draught control






















controllers are installed on an adapter plate that replaces

The chimney draught should be at least 18 Pa
(20 kW) and 22 Pa (30 kW). If such parameters
cannot be ensured, disassemble a couple of turbula-
tors or use an exhaust fan.
ATTENTION
Swing axle adjustment




LEK
LEK
LEK
X
Lock screws