Nibe SPLIT User Manual

Apply a bead of adhesive along the
outer edge of the rear side of the
upper EPP component (225 623).
Note! Follow the instructions on the
adhesive packaging.
Position the upper EPP component
(225 623) as illustrated.
12.
UN
Replace the top cover.13.
Connect the power and start the
heat pump system.
14.
Vent again if necessary. Check the
system pressure on the manometer
(BP5).
15.
Refit the covers.16.
| GB24

Nibe SPLIT Specifications

General

Brand	Nibe
Model	SPLIT
Category	Heat Pump
Language	English