Need help?Do you have a question about the Nibe S1255-12 and is the answer not in the manual?
General| Nominal heating power | 12 kW |
|---|---|
| Refrigerant | R410A |
| Energy efficiency class heating 35°C | A+++ |
| Smart Grid ready | Yes |
| Internet connectivity | Yes |
| Heating capacity | 12 kW |
Guides on setting the temperature for the installation's climate system.
Manual describes installation and service procedures for specialists.
Checklist for inspecting brine side, heating medium side, and electrical components before commissioning.
Instructions for transporting and storing the S1255 unit safely.
Specifies the required free space and installation area considerations for the heat pump.
Guidelines for placing the heat pump on a solid foundation and ensuring stability.
Step-by-step guide on how to remove the front panel of the unit.
Instructions for safely removing the side panels of the heat pump unit.
Details the various pipe connections for heating, cold water, hot water, and brine.
Lists and identifies key heating, ventilation, air conditioning, and sensor components.
Lists and identifies electrical components used in the heat pump.
Illustrates distribution boxes and identifies components within cooling sections.
Identifies and lists the components within the cooling sections.
Detailed instructions for connecting the brine and heating medium sides.
Instructions for connecting cold/hot water, ground water systems, and hot water heaters.
Details the maximum output settings for the immersion heater.
Initial checks and preparations before commissioning the system.
Procedures for filling and venting the climate and brine systems.
Steps for filling and venting the brine system.
Guide for the initial start-up procedure and inspection of the installation.
Details the automatic start guide process for initial system setup.
Explains the commissioning process and the importance of the start guide.
How to set the correct flow for brine and heating medium pumps automatically.
How to manually adjust brine pump speed based on temperature differences.
Guides on manually adjusting the heating medium pump speed using diagrams.
How to set the heating curve for optimal indoor temperature and energy efficiency.
Step-by-step guide for adjusting the heating curve, slope, and offset.
Settings for controlling indoor climate, including temperature, ventilation, and advanced options.
Setting the desired temperature for heating operation.
Setting and viewing the heating curve for optimal indoor temperature.
Settings for hot water demand, temperature increases, and circulation.
Selecting hot water demand modes (Smart control, Small, Medium, Large).
Settings for operating modes, plus functions, and system preferences.
Setting the operating mode (Auto, Manual, Add. heat only) for the heat pump.
Settings for connecting the system to myUplink and the network.
Managing myUplink connection, users, and connection strings.
Setting up schedules for heating and hot water temperature changes.
Access to service functions, settings, and troubleshooting tools.
Making operational settings for the system, covering hot water, pumps, compressor, etc.
Advanced settings for circulation pumps, including operating modes and speeds.
Settings for controlling additional heat during emergency mode.
General system settings, including operating priority and auto mode settings.
Manually starting the initial system setup guide.
How the system operates in emergency mode, including active functions.
Detailed steps for removing the cooling module, including disconnecting pipes and connectors.
Handling alarms, including viewing alarm details and resetting them.
Troubleshooting steps for low hot water or lack of hot water.
Troubleshooting steps for low room temperature issues.
Diagnosing and resolving uneven room temperature problems.
Troubleshooting steps when the compressor fails to start.
Troubleshooting steps for high room temperature issues.
Detailed electrical specifications, including voltage, current, and power ratings.
Performance data for heating capacity, supplied power, and COP under various conditions.
Graphical representation of the heat pump's working range for compressor operation.
Diagrams showing specified heating output versus incoming brine temperature for compressor speed.
Diagrams showing specified cooling output versus incoming brine temperature.
Data on the energy efficiency package, including controller contribution and seasonal efficiency.
Comprehensive technical data, including performance figures, power consumption, and system details.
To Next Page
