What to do if my Nice Enclosure gate opens a short distance, then stops and reverses?
If the Nice Enclosure gate opens a short distance, then stops and reverses, there are several things you can check. First, check the UL/Edge input on the gate controller. Also, ensure the limit LEDs are functioning properly. Check the gate's path for any obstructions. Finally, you may need to adjust the Force Settings.
What to do if Nice CBOX1050 gate opens but will not close?
If the Nice Enclosure gate opens but will not close, check the input LEDs. Any that are ON (except 'STOP') indicates a problem with a keying device. Also, check the external safety devices, as any activated safety devices will hold the gate open. Check the limit LEDs; an orange LED indicates both open/close at the same time, so check the limits for failures and replace if necessary. Finally, check the loop detectors, as any activated safety devices can hold the gate open, indicating a problem with the loop detector or ground loop.
Why won't my Nice CBOX1050 Enclosure battery backup system open the gate during a power outage?
If the Nice Enclosure battery backup system will not open the gate upon AC power outage, first check if the backup system is set to open the gate automatically or requires an input to open. Then, check the batteries for proper voltage and replace them if necessary. Finally, check the incoming Main DC Power.
What to do if Nice CBOX1050 shows Hard Shutdown, LED blinking, and Buzzer sounds?
If the Nice Enclosure gate experiences a hard shutdown (two back to back obstructions), indicated by an LED blinking and a buzzer sounding for 5 minutes, the first thing to do is clear any obstructions from the path of the gate. Then, press the RESET button to clear the system, or use the hard reset button.
Why does my Nice CBOX1050 gate open by itself?
If your Nice Enclosure gate opens by itself, check the accessory inputs and clear them as necessary. Also, check to ensure the Event programming has not been set to open the gate at a particular time.
What does it mean if my Nice Enclosure 1050 display shows repeated 'Nice Apollo 1050' when a button is pressed?
If the Nice Apollo 1050 display shows repeated 'Nice Apollo 1050' messages when a button is pressed, check the battery voltage and replace the battery if necessary.
How to fix Nice Enclosure gate moving in the opposite direction?
If the Nice Enclosure gate moves in the direction opposite to what is expected, reverse the actuators' Red and Black motor wires connected to the 1050 control board.
What to do if Limit LED glows green when Nice CBOX1050 gate is closed, and red when open?
If the Limit LED glows green when the Nice Enclosure gate is closed and red when open, reverse the actuators' Orange and White encoder wires connected to the 1050 control board.
General introduction to the 1050 control box, its applications, and features.
Safety procedures for handling 120VAC power connections and grounding.
Defines different usage classes for gate operators according to UL325 safety standard.
Important safety precautions and guidelines for installing the gate operator.
Lists necessary tools, materials, and power requirements for installation.
Step-by-step guide for mounting the control box and connecting power options.
Procedure for teaching the gate its open and close limits for proper operation.
Identifies control board components and navigation for programming settings.
Details on connecting accessories like sensors, outputs, and communication devices.
Troubleshooting guide, maintenance schedule, and installation checklist for the system.
To Next Page
General