To Next PageTo Next PageWhat to do if Nice Garage Door Opener flashing light is not working?
If your Nice Garage Door Opener is working, but the flashing light isn't, check if the Flash terminal of the flashing light is receiving power during operation (it should be roughly 10–30 VAC). If it is powered, the lamp is likely faulty and needs replacement.
Why does my Nice ECCO5BO start then reverse?
If your Nice Garage Door Opener starts to move but then immediately reverses, it might be because the 'motor force' setting is too low. First, make sure nothing is blocking the door's path. If there are no obstructions, you may need to increase the motor force setting.
General| Brand | Nice |
|---|---|
| Model | ECCO5BO |
| Category | Garage Door Opener |
| Language | English |
Overview of the main installation phases: observation, installation, connection, start-up, and programming.
Instructions for installing the gearmotor with existing or new racks.
Procedure for connecting various devices and power supply to the main control unit.
Detailed wiring diagrams and connections for the automation system.
Procedure for the first start-up, requiring a qualified electrician.
Guide to programming the automation system.
Crucial safety advice for installation and use to prevent damage and injury.
Specific precautions to take before and during the installation process.
Step-by-step guide for installing the gearmotor when a new rack needs to be mounted.
Instructions for installing the gearmotor when the rack is already in place.
Crucial instructions for safely connecting the system to the mains power supply.
Overview of control unit keys and initial checks before programming.
Procedure to make the control unit recognize connected devices on the ECSBus and Stop terminals.
Solutions for common problems like no radio signal, manoeuvre failure, and reverse runs.
