What to do if Nice Garage Door Opener starts then reverses?
If your Nice Garage Door Opener starts to move but immediately reverses, it might be due to obstructions. Try increasing the force setting as described in the manual section 9.1.1.
What to do if Nice FILO400ST/AU01 manoeuvre fails to start and auto led isn't on?
If the Nice Garage Door Opener isn't starting and the auto led isn't on, verify that the Stop input is active, indicated by the Stop LED being lit. If it's not lit, inspect the device connected to the Stop input.
General| Model | FILO400ST/AU01 |
|---|---|
| Category | Garage Door Opener |
| Motor Type | DC |
| Remote Control | Yes |
| Safety Sensors | Yes |
| Battery Backup | Optional |
Important safety instructions and precautions to be followed during installation.
Checks to ensure the gate and its surroundings are suitable for automation.
Ensuring the product's specifications are compatible with the intended use and environment.
Guidance on site preparation and electrical cable layout before installation begins.
Step-by-step instructions for mounting the gearmotor onto the gate system.
Procedure for installing the gearmotor when the rack needs to be mounted.
Procedure for installing the gearmotor when an existing rack is present.
Procedure for wiring various devices to the main control unit.
Instructions for connecting the system's power supply, including mains and optional sources.
Procedure to make the control unit recognize all connected devices on the ECSBus.
Procedure to memorize the gate's travel limits for automatic opening and closing.
Procedure to memorize the initial transmitter for system control and operation.
Steps to verify the proper operation of the automation system after installation.
Final checks and procedures required to put the automation system into operation.
Crucial safety warnings and precautions for operating and maintaining the system.
To Next Page
