Nice FLOR Series - Entering Code Number (Normal Way); Entering Code Number (Remotely)

Entering a code number (normal way)
This operation too will let you add the code number of a new transmitter to the receiver’s memory.
1) Press the key on the receiver for a moment
: the LED will turn on for 5 seconds. Within this time
you must:
2) Transmit the code number until the LED turns off pressing any key on the transmitter.
3) Release the transmitter key and wait a second.
4) Transmit the code to confirm by pressing any key on the transmitter.
The LED will now flash 3 times meaning that the operation was done properly; if this does not
happen, repeat the whole procedure from the beginning. Repeat the whole procedure if you want to
enter a new code number.
Entering a code number (remotely)
To enter the code number of a new remote control without using the receiver key you will need an
authorised remote control (note: the first remote control must always be entered using the receiver
key). Now, with the two remote controls, which we shall call NEW (the one whose code number we
want to enter) and OLD (the authorised one), position yourself in their range of action and then:
- 45 -
GB