1) Transmit the NEW code number for at least 5 seconds pressing any key on the NEW
transmitter.
And then slowly:
2) Transmit an OLD code number 3 times pressing any key on the OLD transmitter 3 times.
3) Transmit the NEW code number ONCE to confirm pressing any key on the NEW transmitter.
Now the new code number has been entered and you can repeat this procedure immediately with
another remote control.
ATTENTION!! : this operation enters the new code number in all the receivers within the range
of action that recognise the old code number. If there are several receivers nearby with the
old code number, turn the ones off that you do not want to receive the new code number.
DELETING A CODE NUMBER
If you want to delete a code number from the receiver’s memory proceed as follows:
1) Hold the key down on the receiver (about 3 seconds) when the LED turns off let go of the key.
2) Transmit the code until the LEDs turn off again pressing any key on the transmitter.
3) Release the key on the transmitter and wait 1 second.
4) Transmit the code to confirm pressing any key on the transmitter.
- 46 -
To Next Page
Loading...
