The LED will now flash once to indicate that the code has been deleted. If this does not
happen repeat the procedure from the beginning.
DELETING ALL CODE NUMBERS
With this operation all the code numbers stored are deleted (emptying the memory), the 2
nd
learning
disabling function is also cancelled and TIMER time is set at 3 seconds.
1) Hold the key down on the receiver, the LED will turn off after 3 seconds.
2) Release the key during the 3
rd
following flash.
3) Wait about 3 seconds.
4) Press the key as soon as the LED turns back on and release it as soon as it turns off.
The operation may take several seconds depending on memory type. During this phase the LED will
flash quickly followed by 5 slow flashes to indicate that it has been reset and the memory is empty;
if this does not happen repeat the procedure from the beginning.
- 47 -
GB
To Next Page
Loading...
