The memory cards must always be of the same type.
When the receiver is turned on it displays the type of memory card being used. If it is a BM60, the
LED will flash briefly. If it is a BM250 the LED will flash twice while if it is an BM1000 the LED will
flash three times.
All the codes are stored in the memory, so when maximum security is required the code learning
function must be disabled (this can also be done remotely). After the code numbers of the remote
controls being used have been entered, break the track indicated by an arrow (Fig. 4). If, later on,
you wish to enter other code numbers, join the two pads with a dot of solder (Fig. 5)
ATTENTION!!: Turn the receiver off before pulling out or plugging in a memory card
- 36 -
051A LS
051A LS
Fig. 4 Fig. 5
CUT JOIN
To Next Page
Loading...
