Nice FLOX1R User Manual

DELETING A CODE NUMBER
If you want to delete a code number from the receiver’s memory proceed as follows:
1) Hold the key down on the receiver (about 3 seconds) when the LED turns off let go of the key.
2) Transmit the code until the LEDs turn off again pressing any key on the transmitter.
3) Release the key on the transmitter and wait 1 second.
4) Transmit the code to confirm pressing any key on the transmitter.
The LED will now flash once to indicate that the code has been deleted. If this does not happen
repeat the procedure from the beginning.
DELETING ALL CODE NUMBERS
With this operation all the code numbers stored are deleted (emptying the memory), the 2nd learning
disabling function is also cancelled and TIMER time is set at 3 seconds.
1) Hold the key down on the receiver, the LED will turn off after 3 seconds.
2) Release the key during the 3
rd
following flash.
3) Wait about 3 seconds.
4) Press the key as soon as the LED turns back on and release it as soon as it turns off.

Nice FLOX1R Specifications

General

Brand	Nice
Model	FLOX1R
Category	Transmitter
Language	English

Summary

Introduction to Radio Control Systems

Transmitter Installation and Checks

Receivers with Terminal Connections

Wiring Receivers with Terminals

Details power supply, relay outputs, and aerial input wiring for terminal receivers.

Plug-in Receivers Installation

Plug-in Receivers Wiring

Explains power, aerial, and output connections for plug-in receivers.

Memory Card Functionality

Memory Card Security Features

Disabling Function Types

Describes hardware, software, and password-based disabling functions for security.

Adjustments and Channel Settings

Relay to Channel Association

Configures output relays to specific transmitter channels using jumpers.

Output Contact Configuration

Normal Open/Closed Contact Setup

Special Relay Functions

Aerial Installation Guide

Aerial Placement and Connection

Details optimal aerial height, cable types, and connection points.

Transmitter Programming Overview

Programming Status Codes

Slow Flashing Codes (1/2 second)

Fast Flashing Codes (1/4 second)

Fast Code Entry Method

Standard Code Entry Method

Normal Code Entry Procedure

Remote Code Entry Procedure

Deleting Code Numbers

Delete Single Code Number

Step-by-step instructions to remove a specific code from memory.

Delete All Code Numbers

Instructions to erase all codes, reset functions, and clear memory.

2nd Learning Disabling Function Management

Activating the 2nd Disabling Function

Removing the 2nd Disabling Function

Programming Timer Time

Timer Programming Procedure