INSTALLATION
Transmitters:
The transmitters are ready to use, each with
their own code number set during
construction. To see if they are working
properly simply press one of the keys and
check that the red LED is flashing, indicating
transmission.
The transmitter has a device built into it that
controls battery state: press one of the keys
and if the battery is fully charged the LED will
give an initial pulse followed immediately by
the transmission signal. If the battery is partly flat the LED will give the first pulse and start
transmitting only after half a second.
In this case we advise you change the battery as soon as possible.
If, on the other hand, the battery is completely flat the LED will flash at half-second intervals without
transmitting and the battery must be changed immediately.
To Next Page
Loading...
Need help?
General
