English – 12
EN
a movement from a limit switch. Warning! - It is advisable to programme a slightly longer duration (by a few seconds) with respect to the time
necessary to complete the manoeuvre.
s:KDWLVWKHq3DXVH7LPHr" It is the time for which the control unit waits to re-close the door automatically, once the user has sent an opening
BNLL@MCETMBSHNM@TSNL@SHMFQDBKNRHMF3GDOQNFQ@LL@AKD/@TRD3HLDK@RSREQNLRDBNMCRLHMHLTLSNRDBNMCRL@WHLTL3GD
/@TRD3HLDB@M@KRNADDKHLHM@SDCDMSHQDKXSGHRRDQUDRSNdisable automatic re-closing.
7RPHPRULVHWKHq:RUN7LPHrDQGWKHq3DXVH7LPHr
01.
Bring the door to the low limit switch.
02.
Press and hold button T1NMSGDBNMSQNKTMHS@RRNNM@RSGDLNSNQRS@QSRLNUHMFtowards the high limit switchRS@QSBNTMSHMFRDB-
NMCR SSGDDMCNESGDRDBNMCRthe control unit will start memorising the duration of the manoeuvre;
03.
Continue holding button T1; wait for the manoeuvre to end at the high limit switch; wait a few seconds more and then release the but-
ton. The motor will stop and the control unit will memorise the new Work Time that has just been counted.
04.
Within 2 seconds from the motor’s stoppage, press and hold button T1NMSGDBNMSQNKTMHSEQNLSGHRLNLDMSSGDPause Time will start
being measured.
05.
Release button T1 after the desired time has elapsedL@WHLTLRDBNMCRSGDBNMSQNKTMHSVHKKBNLL@MCSGDLNSNQSNODQENQL@
downward manoeuvre while it memorises the time that has just been measured. This time will subsequently be used for the auto-
matic re-closing of the door.
IMPORTANT3GDOQNFQ@LLDC/@TRD3HLDVHKKNMKXADDWDBTSDCHECHORVHSBGHRRDSSN.-
7RPRGLI\WKHq:RUN7LPHrDQGWKHq3DXVH7LPHr
01. 3NLNCHEXSGDf6NQJ3HLDt@KNMDQDOD@SSGDOQNBDCTQDEQNLSGDADFHMMHMF@MCRSNO@S2SDO
7RGLVDEOHWKHq3DXVH7LPHr
01.
To disable automatic re-closing and, therefore, eliminate the Pause Time, repeat the procedure from the beginning and stop at Step 4.
KSDQM@SHUDKXSGD@TSNL@SHBQDBKNRHMFB@MADCHR@AKDCAXOTSSHMFCHORVHSBGSN.%%
To Next Page
Loading...
Need help?
General
