English – 8
EN
6.B.7 Professional
To cancel a combination for both command keys: ▲
(output-1) and ▼ (output-2) (reference digit: “4-5”)
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digits “4-5”. – Press ▼ to confirm.
03. Enter the combination you want to cancel. – Press ▼ to confirm.
04. Enter the combination again. – Press ▼ to confirm. If the procedure was suc-
cessful, the keypad will beep 3 times.
6.B.8 Professional
To count the number of combinations for command key
▲ (output-1) only (reference digit: “6”)
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digit “6”. – Press ▼ to confirm. – A sequence of beeps will follow: their
meaning is given in Table 4.
To obtain the total number of combinations mapped to key ▲ (output-1), you must
include all those which are programmed to activate both outputs. To calculate the
latter, run procedure 6.B.10.
6.B.9 Professional
To count the number of combinations for command key
▼ (output-2) only (reference digit: “7”)
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digit “7”. – Press ▼ to confirm. – A sequence of beeps will follow: their
meaning is given in Table 4.
To obtain the total number of combinations mapped to key ▼ (output-2), you must
include all those which are programmed to activate both outputs. To calculate the
latter, run procedure 6.B.10.
6.B.4 Professional
To change the Professional programming password
(reference digit: “3”)
You can change the password whenever you want (the factory default is: 0-3-3-3-3-
3-3). To modify it, you must know the last valid password.
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digit “3”. – Press ▼ to confirm.
03. Enter a new password for Professional mode programming, using seven digits
chosen personally. – Press ▼ to confirm.
04. Enter the new password again. – Press ▼ to confirm. If the procedure was suc-
cessful, the keypad will beep 3 times.
6.B.5 Professional
To delete a combination for command key ▲ (output-1)
only (reference digit: “4”)
If the combination applies to both outputs, this procedure will only cancel output-1. It
will remain valid for output-2.
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digit “4”. – Press ▼ to confirm.
03. Enter the combination you want to cancel. – Press ▼ to confirm.
04. Enter the combination again. – Press ▼ to confirm. If the procedure was suc-
cessful, the keypad will beep 3 times.
6.B.6 Professional
To delete a combination for command key ▼ (output-2)
only (reference digit: “5”)
If the combination applies to both outputs, this procedure will only cancel output-2. It
will remain valid for output-1.
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digit “5”. – Press ▼ to confirm.
03. Enter the combination you want to cancel. – Press ▼ to confirm.
04. Enter the combination again. – Press ▼ to confirm. If the procedure was suc-
cessful, the keypad will beep 3 times.
To Next Page
Loading...
Need help?
General
