Nice Oview

English – 4
To use Oview as a fi xed control for automations, it must be installed in a suit-
able location, out of the reach of children and at a height of at least 150 cm
from the ground.
To mount the device on a wall, use the support supplied in the pack, as shown
in fi g. 2.
Then connect Oview to the automation with reference to the instructions in
Chapter 3.
––– OBLIGATIONS FOR THE INSTALLER –––
IMPORTANT – After installing and programming Oview as a control
device, the installer must provide the client with the part of this manual
entitled “User Manual”.
Also, if the installer intends to enable the client access to a number
of programming functions, the relative information on these functions
must also be supplied, contained in the web site www.nice-service.
com, under the “Download” section.
OVIEW INSTALLATION
AS A CONTROL DEVICE
2
2
EN