1 - English
EN
1
PRODUCT DESCRIPTION
OXI is a radio receiver designed for being installed on a control unit for automating gates, garage doors and
road barriers.
– All uses other than the intended use described and use in environmental conditions other than
those described in this manual should be considered improper and forbidden!
• Other product characteristics
– The receiver is compatible with the unidirectional radio codes “O-Code”, “O-Code/A”, “FloR”, “FloR/A”,
“Smilo” and “Flo”. In particular, the “O-Code” and “O-Code/A” encoding systems allow for exploiting all the
advanced and exclusive functions of the “NiceOpera” system.
– The control unit’s receiver has 1024 memory locations to memorise transmitters: one location can alterna-
tively memorise a single transmitter (if its keys are memorised as a “single set”, with the Mode 1 procedures
– read Paragraph 3.1), or a single key (if memorised with the Mode 2 procedures – read Paragraph 3.2).
–Eachreceiverhasitsownidenticationnumber,knownasthe“Certicate”.Thisallowsforaccessingseveral
operations, such as, for example: the memorisation of new transmitters without having to access the receiver,
and the use of the O-View programmer through its “BusT4” connection to the control unit.
– This receiver can be used solely with control units equipped with “SM”-type plug connector (verify the most
suitable control units on the Nice product catalogue or on the www.niceforyou.com website).
ENGLISH
Instructions translated from Italian
To Next Page
Loading...
Need help?
General
