Need help?Do you have a question about the Nice RO500 and is the answer not in the manual?
General| Mains power supply | 230 Vac 50 Hz |
|---|---|
| Max. power absorption | 400 W |
| Line Absorption | 1.7 A |
| Max. Service current 24 V | 150 mA (voltage can vary by ± 25%) |
| Motor | Asynchronous-single phase |
| Limit switch type | Electromechanical |
| Built-in capacitor | 12 nF |
| Input impedance | 52 ohm |
| Protection rating | IP 44 |
| Thermal protection | 140 °C |
| Operating temperature | From -20 °C to +50 °C, from -20 to +55° C |
| Maximum torque (corresponding to force) | 15 Nm (500 N) |
| Nominal torque (corresponding to force) | 8 Nm (270 N) |
| Nominal speed | 0.18 m/s |
| Max. No. Cycles per hour | 9 (leaf 7 metres) |
| Max. No. consecutive Cycles | 5 |
| Work time | Adjustable from 2.5 to > 40 s., or from < 40 to > 80 s. with TLM |
| Pause time | Adjustable from 5 to > 80 s. |
| Sensitivity | Better than 0.5 V |
| Flashing light output | For connection of flashing light to power mains (Max. power 40 W) |
| Decoding | “O-Code” / “FloR” / “TTS”; or Flo”; or “Smilo” |
| Reception frequency | 433.92 MHz |
Weight and Dimensions| Maximum leaf weight | 500 Kg |
|---|---|
| Maximum leaf length | 7 m |
| Dimensions | 290 x 195 x h 250 mm |
| Weight | 8 Kg |
Provides critical instructions and warnings for safe installation and operation of the product.
Ensures product components, model suitability, and environment conditions are checked before installation.
Verifies gate mechanical structure, weight, and dimensions against product limits and standards.
Procedures for testing each automation component and system safety devices.
Steps for finalising automation setup and providing documentation to the owner.
Essential safety information for end-users, emphasizing safe operation and maintenance.
Instructions for manual gate operation during power failures or system malfunctions.
To Next Page
