Nice WIDE L Installer's Instructions

3
Be Safe!
WARNING!! These are the general safety obligaons for the installers and users of ET Nice (Pty)
Ltd automaon equipment. A copy of this document also appears in the user instrucons. Those
instrucons must be issued to the responsible end user during the handover and instrucon
meeng.
1. Only suitably qualied persons, may install, repair or service the product. Unless expressly indicated in the user instrucons, no
user serviceable components can be found inside any ET Nice (Pty) Ltd automaon product.
2. It is important for personal safety to study and follow all the instrucons carefully. Incorrect installaon or misuse may cause
serious personal harm.
3. Keep the instrucons in a safe place for future reference.
4. This product was designed and manufactured, strictly for the use indicated in the accompanying documentaon. Any other use
not expressly indicated in the documentaon, may damage the product and/or be a source of danger. ET Nice (Pty) Ltd cannot
accept responsibility for improper use or incorrect installaon of this product.
5. ET Nice (Pty) Ltd cannot accept responsibility if the principles of good workmanship are disregarded by the installer.
6. ET Nice (Pty) Ltd cannot accept responsibility regarding safety and correct operaon of the automaon, if other manufacturers’
equipment is added to this product.
7. Do not make any modicaons or alteraons to this product. Do not substute any component of this product with any other
component not expressly designed into this product.
8. Anything other than expressly provided for in the accompanying instrucons is not permied.
Prior to installaon:
1. All unnecessary ropes, chains and fasteners must be removed and all unnecessary latches or locks must be disabled from locking.
2. The barrier or door must be balanced correctly where it, neither opens nor closes from any posion under its own load. When
operated by hand the barrier or door should be free of hindrance and easily moved (In the case of a garage door if the balancing
springs need to be adjusted the adjustment should only be carried out by a qualied and experienced person).
3. The construcon of the barrier or door must be sound and automatable. It is the responsibility of the installer to ensure that the
mechanical components of the barrier or door system are sucient to withstand the necessary forces in cases of overload.
4. It is the responsibility of the installer to ensure the barrier or door is suciently trapped within its range of travel by means of
mechanical ends of travel stoppers.
5. Ensure all xed mounng points, such as the wall above the door in a garage door system or the posts in a swing barrier system,
are sound and strong enough to allow proper xing of the operator.
6. It is the responsibility of the installer to ensure the installed posion selected for this product, falls within the limitaons of the
products ingress protecon rang.
7. Ensure the area of installaon is not subject to explosive hazards. There should be no volale gasses or fumes as these can present
a serious safety hazard.
8. All ET Nice (Pty) Ltd garage door operators are supplied with a sealed 15A safety plug on lead for use in an electrical code of pracce
approved plug point. Do not extend, modify or replace the plug lead unless duly qualied as an electrician. Before installing the
unit, ensure the mains supply is switched o.
9. ET Nice (Pty) Ltd barrier operators are supplied with a terminal connecon for the electrical supply beneath the screwed down
cover of the operator. In the case of a model requiring 220Vac supply at the operator, an all pole negavely biased switch, with a
contact opening of greater than 3mm must be installed within 1.5m of the operator. This switch must be clear of all workings of
the system and must be in a posion secure from public access. This switch and its connecons must be inspected and passed by
a cered electrician prior to using it.
10. It is the responsibility of the installer to ascertain that the designated persons (including children) intended to use the system,
do not suer reduced physical sensory or mental capabilies, or lack of experience and knowledge, unless they have been given
supervision or instrucon concerning the use of the system by a person responsible for their safety.
11. The drive may not be installed on a door incorporang a wicket door, unless the drive is disabled by the release of the wicket door.
(Wicket door :- A pedestrian door within the main barrier or door)
1. Ensure the working area is clear of obstrucons and obstacles.
2. Install the safety warning scker within clear view of where the barrier or door will be operated from. Typically this would be
adjacent to any xed trigger switches or on the barrier or door itself.
3. The emergency manual release must be installed where it is no higher than 1.8m from the oor level. This would apply to the cord
in a garage installaon or the lockable lever in a barrier installaon.
4. Any addional xed door control switches such as wall consoles or keypads, if installed, must be at a height of at least 1.5m, within
clear sight of the barrier or door and away from any moving components of the system.
During installaon:
Connued overleaf.......

Nice WIDE L Specifications

General

Brand	Nice
Model	WIDE L
Category	Control Systems
Language	English