Nice WIDE L Installer's Instructions

4
5. It is highly recommended that a set of safety infra-red beams be used in conjuncon with this product. The safety beams must be
installed in such a way that the product is prevented from running when anything is in the path of the door or barrier.
6. Over and above the recommendaon to use safety infra-red beams with this product it is mandatory to install and use a safety
beam set when using the automac closing feature. It is recommended that a warning light be ed to any automaon system.
7. The barrier or door warning labels must be installed in a prominent place and/or adjacent to any xed controls that trigger the
system. These must be in clear line of sight of the barrier or door opening.
8. The emergency manual release instrucon label must be installed on or adjacent to the emergency manual release mechanism.
Aer installaon - It is the responsibility of the installer to ensure the users:
1. Is procient in the use of the manual emergency release mechanism.
2. Is issued with the documentaon accompanying this product.
3. Understands that the barrier or door may not be operated out of clear sight.
4. Ensures that children are kept clear of the barrier or door area at all mes, and that children do not play with the remote
transmiers or any xed trigger switches linked to the system.
5. Is instructed not to aempt to repair or adjust the automaon system and to be aware of the danger of connuing to use the
automaon system in an unsafe condion before a service provider aends to it.
6. Is procient in tesng the unit’s safety obstrucon sensing system.
7. Is aware of what to check for with regards to wear and tear that may need to be aended to from me to me by the service
provider.
8. Is aware that a fagued baery may not be disposed of in the general refuse and must be handed in at a baery merchant for safe
disposal. Before removing the baery from the system the household mains must be disconnected. In the case of the motor unit
being removed and scrapped, the baery must be removed rst.
TECHNICAL SPECIFICATIONS
Technical Data WIDE M and WIDE L
Primary power supply. 220 – 240Vac @ 50Hz – 60Hz.
Peak power consumpon. 240W
Electrical class. Class 1.
Motor voltage. 24Vdc.
Motor current. Current limited to 10A.
Built in baery charger. Mulple stage auto-calibrang (Peak - 500mA)
Number of operaons, within 24hrs of power
failure, on baery reserve.
(Baery health and charge level at me of
power failure dependent)
650 Using 1 x 24V 5Ah baery. (Standard in kit)
950 Using 2 x 24V 3.5Ah baeries.
1300 Using 2 x 24V 5Ah baeries.
Maximum operaons per day. 3000
Duty cycle with mains present.
Boom pole open/close speed selecon depen-
dent.
98%
Operang speed.
Wide M = 90°/3,5s.
Wide L = 90°/5s.
Torque.
Wide M = 140Nm.
Wide L = 200Nm.
Operang temperature range. -10 to 50° C (14F to 122F)
An-crushing safety sensing. Yes – Electronic load proling.
Auxiliary supply output. 12Vdc @ 400mA.
Receiver format. ET BLU MIX © backward compable with ET BLUE. (Rolling code)
Receiver frequency. 433.92MHz.
Receiver channels. 4CH (BT, Open only, Aux relay, Holiday lock-out)
Receiver memory capacity. 1023 users.
All users can be allowed control of all channels. Yes.
Ingress protecon. IP44
Physical dimensions. See next page.
Technical specicaons.

Nice WIDE L Specifications

General

Brand	Nice
Model	WIDE L
Category	Control Systems
Language	English