English – 9
07. Set the DIRECTION OF THE BOOM:
If you require LEFT-ORIENTED BOOM with the cabinet on the right (the factory setting), move to step 08 for the adjustment of
the balancing spring (N.B. in the factory it is anchored in non denitive holes)
WIDE S
WIDE M WIDE L
7 m.
A
Only with 7 m boom place the balancing springs as shown in Figure “A”
If you require RIGHT-ORIENTED BOOM with the cabinet on the left, you must proceed as follows:
7 m.
A
WIDE S
WIDE
M
WIDE
L
rotate through 180° the motor connector (MOTOR - Fig. 5) and the connector of the limit switches (LIMIT SWITCH - Fig. 5)
180°
180°
To Next Page
Loading...
